четверг, 7 февраля 2019 г.

Netapp - Вывод контроллера из режима lockdown

************************************************************
*Default E-Series Contoller Shell Passwords
************************************************************
NetApp Systems:
06.xx CFW and below (VxWorks 5.x): infiniti/infiniti
07.xx and 8.xx: shellUsr/wy3oo&w4 (In some early 7.xx cases this may be shellUsr/infiniti instead)
11.30.x: eos/wy3oo&w4 (for eos shell) and diag/wy3oo&w4 (for dom0/linux shell)
11.40.x: eos/<UI admin password> (for eos shell) and diag/<UI admin password> (for dom0/linux shell)
SPRI Login: spri/SPRIentry

OEM Systems:
Apollo (SUN/Oracle): shellUsr/y2llojp
Mercury (Dell) As of x.03 NVSRAM: DF4m/2> (shell) and supportDell (SPRI)
Catera (IBM) 07.10 and above: shellUsr/wy3oo&w4 (In some cases this may be shellUsr/infiniti
instead)

************************************************************
*Default E-Series Contoller Setting IP addresses
************************************************************
https://E2800_Controller_IP

Controller 1 (port 1): IP Address: 192.168.128.101/24
     (port 2): IP Address: 192.168.129.101/24
Controller 2 (port 1): IP Address: 192.168.128.102/24
     (port 2): IP Address: 192.168.129.102/24

************************************************************
*Global System Reset
************************************************************

Не моё :)

All command should be run shellUsr/wy3oo&w4

Run the following command
-> sysWipe
Warning: This command is extremely destructive.  As such, it should not be used as part of configuration restoration.
If you are NOT planning on restoring the configuration / recovering user data, you may perform sysWipeAllConfigData.
If you ARE planning on restoring the configuration / recovering user data, you may perform bdbmClearPrimaryDatabase
as part of the recovery procedure.
value = 35 = 0x23 = '#'
-> sysWipeAllConfigData
-> sysReboot

#if Controller A is lockdown

Run the following command on both controllers
>lemClearLockdown
>clearHardwareLockdown
>psvClearSodRebootLoopCounter

then hardware unplug controller A and run the following command on ctrl-B
>loadDebug
>cmgrSetAltToFailed
>cmgrSetAltToOptimal
Then Hot-plug controller A

************************************************************
*System Administrator Reset Password
************************************************************
1. Use SPRI Login: spri/SPRIentry and go to point 4
2. Use the shellUsr/wy3oo&w4 and type "spriMenuPwdReset", password should be reseted.

Комментариев нет:

Отправить комментарий